Siemens 440 - Manual (Page 60)

Parameter Description Issue 01/06
MICROMASTER 440 Parameter List
60 6SE6400-5BB00-0BP0
P0352[3] Cable resistance Min: 0.0
CStat: CUT Datatype: Float Unit: Ohm Def: 0.0
P-Group: MOTOR Active: Immediately QuickComm.: No Max: 120.0
Describes cable resistance between inverter and motor for one phase.
d
M
l
l : Cable length d : Cable diameter
A : Cable cross-section
: Specific resistance ρ
A
l
R ⋅ ρ =
2
2
d
A 





⋅ π =
m
mm
0,0178
2
Cu
⋅ Ω
= ρ
Inverter
Index:
P0352[0] : 1st. Drive data set (DDS)
P0352[1] : 2nd. Drive data set (DDS)
P0352[2] : 3rd. Drive data set (DDS)
P0354[3] Rotor resistance Min: 0.0
CStat: CUT Datatype: Float Unit: Ohm Def: 10.0
P-Group: MOTOR Active: Immediately QuickComm.: No Max: 300.0
Sets rotor resistance of motor equivalent circuit (phase value).
Index:
P0354[0] : 1st. Drive data set (DDS)
P0354[1] : 2nd. Drive data set (DDS)
P0354[2] : 3rd. Drive data set (DDS)
Dependency:
Calculated automatically using the motor model or determined using P1910 (motor identification).
P0356[3] Stator leakage inductance Min: 0.00001
CStat: CUT Datatype: Float Unit: - Def: 10.00000
P-Group: MOTOR Active: Immediately QuickComm.: No Max: 1000.00000
Sets stator leakage inductance [mH] of motor equivalent circuit (phase value).
1000
0356 P
0310 P 2 L f 2 L X
S S S
⋅ ⋅ π ⋅ = ⋅ ⋅ π ⋅ = ⋅ ω =
σ σ σ
Stator leakage reactance:
Index:
P0356[0] : 1st. Drive data set (DDS)
P0356[1] : 2nd. Drive data set (DDS)
P0356[2] : 3rd. Drive data set (DDS)
Dependency:
Calculated automatically using the motor model or determined using P1910 (motor identification).
P0358[3] Rotor leakage inductance Min: 0.0
CStat: CUT Datatype: Float Unit: - Def: 10.0
P-Group: MOTOR Active: Immediately QuickComm.: No Max: 1000.0
Sets rotor leakage inductance [mH] of motor equivalent circuit (phase value).
1000
0358 P
0310 P 2 L f 2 L X
R R R
⋅ ⋅ π ⋅ = ⋅ ⋅ π ⋅ = ⋅ ω =
σ σ σ
Rotor leakage reactance:
Index:
P0358[0] : 1st. Drive data set (DDS)
P0358[1] : 2nd. Drive data set (DDS)
P0358[2] : 3rd. Drive data set (DDS)
Dependency:
Calculated automatically using the motor model or determined using P1910 (motor identification).
Level
3
Level
4
Level
4
Level
4