Lenze ETC Motion Control - Manual (Page 23)

Getting started
Establishing the communication between PC and ETCHx
Starting the terminal program "HyperTerminal" and activating the monitor interface
2
2.4
2.4.2
l
23 EDSTCXN EN 2.0
As soon as a connection has been established between the PC and ETC, the
LEDs 1 ... 6 at the ETCHx start to flash circulatingly. The message "Wait Boot
Loader" appears and the following window is displayed:
ETCM009
7. Press the <?> key until the prompt ">" appears.
ETCM010
The monitor interface has been started. You can now send commands to
the ETC via the keyboard.