Lenze ETC Motion Control - Manual (Page 85)

Getting started
Updating the firmware of the ETCHx in the "Standalone" operating mode
Updating the firmware
2
2.16
2.16.3
l
85 EDSTCXN EN 2.0
Firmware file names: ETCHC_A.rsc (ETCHC with 4 MB) or ETCPC.rsc
(ETCPC)
ETCN098
3. Click on Send.
While the file is being loaded into the control system, the following figure
is displayed. On the ETC front plate, the LEDs 1 ... 6 flash circulatingly.
ETCN099
After loading is complete, the following figure is displayed:
ETCN100
The control system waits until the firmware is loaded; on the ETC front
plate, the LEDs 1 ... 6 light up circulatingly.
4. In the HyperTerminal window, enter quit .
The firmware starts. On the ETC front plate, the green watchdog LED
lights up.