Lenze ETC Motion Control - Manual (Page 294)

ETC−MMI
"Setup" operating mode
7
7.4
l
294 EDSTCXN EN 2.0
Target position Target position for the selected axis. Select the desired
axis by means of the <Axis> key (or <Cursor>keys). The
entry must be completed with <ENTER>. <ESC> cancels
the entry and restores the old positions. The function
key is only labelled and enabled if the <Target point
travel> key has been pressed.
Handwheel The handwheel keys are only displayed if a
handwheel is configured in the machine constants.
Traversing the axes via a handwheel. You can select the
axis which you want to traverse by means of the
handwheel via the <Axis> key (or <Cursor> keys).
Handwheel factor Selection of a factor which acts on the traversing speed.
5 handwheel factors are provided (1, 3, 10, 30, 100).
Every time the <Handwheel factor> key is pressed, the
following factor is selected. The function key is only
labelled and enabled if the <Handwheel> key has been
pressed.
back... Back to the previous level.
Datum points...
Reset The actual position of the selected axis is set to zero
(zero shift).
Import The actual position of the selected axis is set to the
entered value.
Correct The actual position of the selected axis is shifted by the
entered value.
S switchover Enter the number of the workpiece coordinate system
(S), complete with <Enter>, cancel with <ESC>. The
entered coordinate system is activated.
back... Back to the previous level.
Tool management... Management of tools and the corresponding change
positions.
Up to 99 tools can be entered and saved. Tool "0" serves
as reference tool and should not be used otherwise. The
tools can be assigned 99 tool magazine positions. Please
note that each magazine position reduces the number
of workpiece coordinate systems (max. 99).
The number of tools and magazine positions managed
in the MMI is determined in the "DelphMMI.ini"
(
^ 327). 30 parameters are available for each tool, six
of which have a fixed meaning:
l Tool length
l Tool radius
l Tool life
l Speed
l Magazine position
l Sister tools
The data is made available in the parts program in the P
field (P700 ... P729) when the tool is selected.