7 etc-mmi, 1 installing etc-mmi, Etc−mmi – Lenze ETC Motion Control User Manual
Page 286: Installing etc−mmi
ETC−MMI
Installing ETC−MMI
7
7.1
l
286
EDSTCXN EN 2.0
7
ETC−MMI
The program "ETC−MMI" is used for the following tasks:
ƒ Configuring the control system
ƒ Operating and monitoring the control system
ƒ Maintenance of the control system and error diagnosis
7.1
Installing ETC−MMI
(
Stop!
Only install the PCI control variant ETCPx after installing the
ETC−MMI and before starting the ETC−MMIs.
)
Note!
The ETC−MMI Gateway is installed during the installation of the
Lenze ETC−MMIs
1. In Windows File Explorer, open the program "setup.exe" on the
ETC−MMI installation CD.
2. Follow the instructions of the installation program. The following will
be requested:
– Demo or standard installation
– Control type (ETCHC or ETCPC)
– IP address of the ETCHC (
¶ 28) or index of the ETCPC (indexes of the
PCI cards are in the range 0 ... 9 and are automatically assigned by the
driver. The first ETCPx has the index 0).
In the start bar, the entry "Lenze ETC−MMI" is created. It can be used to
start the application.
3. For an ETCHC: Check that the TCP/IP protocols are installed in the
network properties (Start
W
Settings
W
Control Panel
W
Network).
For an ETCPC: Install the ETCPC plug−in card in the PC. Observe the notes
in the ETC Hardware Manual.