Getting started – Lenze ETC Motion Control User Manual
Page 26
Getting started
Establishing the communication between PC and ETCHx
Setting the operating mode of the ETCHx
2.4
2.4.3
l
26
EDSTCXN EN 2.0
For the "With MMI" operating mode, the firmware file must be replaced by
the file "NetBoot.rsc" (Loader) on the ETCHx.
1. To delete the firmware, enter the following in the HyperTerminal: del
sd: etc*.rsc. Afterwards, press the <Enter> key.
2. To transfer the Loader to the ETC, activate the menu item Transfer
W
Send File in the HyperTerminal.
ETCM021
3. Specify the path to the file "NetBoot.rsc" and select the protocol
"Zmodem with Crach Recovery".
ETCM022
4. Click on Send.
While the file is being loaded into the control system, the following figure
is displayed. On the ETC front plate, the LEDs 1 ... 6 flash circulatingly.
ETCM023
Set the "With MMI" operating
mode