Lenze ETC Motion Control - Manual (Page 27)

Getting started
Establishing the communication between PC and ETCHx
Setting the operating mode of the ETCHx
2
2.4
2.4.3
l
27 EDSTCXN EN 2.0
After loading is complete, the following figure is displayed:
ETCN007
The control system waits until the firmware is loaded from the PC; on the
ETC front plate, the LEDs 1 ... 6 flash circulatingly.
5. In the HyperTerminal window, enter quit and confirm the command
with <Enter> .
The firmware starts. On the ETC front plate, the green watchdog LED
lights up.