Lenze ETC Motion Control - Manual (Page 318)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
318 EDSTCXN EN 2.0
Machine constants Edit machine constants ( ^ 190).
0 1
3
4
2
ETCN093
0: Available machine constants
1: Date and version of the NC
2: Setting of the current machine constant
3: Change value
4: Description of the machine constant from the
"MK.hlp". Individual parameters can be changed in the
machine constant catalogue.
edit MC When "edit MC" is selected, the current machine
constants are first loaded from the NC computer and
then displayed. They can now be changed. Use the
<TAb> key to select the individual elements in the
dialogue box. If you are in the field in which the
machine constants are listed, you can make the
setting(s) for the selected constant by pressing the
<Space bar>. Entries must be confirmed with <Enter>.
Use the <ESC> key to close the dialogue for changing
the machine constants without adopting the changes.
With <Enter>, you can quit editing. Afterwards, the
changes are sent to the NC and updated in the
configured MC file. Thus, the changed machine
constants will be loaded again during the next start.
load MC Show available machine constant files. To transfer a file
to the ETCxC, select it with the <Cursor> keys and press
<Enter>.
Note: During the next start of the control system, the
MC file entered in the INI file will be loaded.