Lenze ETC Motion Control - Manual (Page 328)

ETC−MMI
Appendix
Configuration file (DELPHMMI.INI)
7
7.8
7.8.3
l
328 EDSTCXN EN 2.0
Description Term Section
LanguagePath Path in which the program looks for the
language files.
language=language Here you can specify the name of an ASCII
file (name extension ".txt" is presupposed).
This file contains general display texts,
additional error messages, the function key
assignment etc. required for the operation
of the MMI software (see also "language
file").
If no entry is made here, a list of files can
be entered in a language section. The
specified text numbers must not be
assigned twice.
Note: All ASCII files can be edited with any
editor (also with the ETC MMI software).
You can thus adapt all texts in the files to
your requirements (e.g. different
language).
left=0 Left window position if doscal <> 0
top=0 Top window position if doscal <> 0
doscal=0 Doscal = 0 means that the software is
presented optically as it was programmed.
doscal <> 0 can be used to change the
window size of the MMI software.
Doscal = 1 means that the complete screen
is made available for the application. The
left upper edge is defined by the terms left
and top.
Doscal = 2 to doscal = 1000 means that the
window size can be changed from 0.2% to
100% of the complete screen size.
Caution: The window can be minimised
such that it can no longer be seen.
watchdog=0 Watchdog <> 0 set offers the possibility to
cyclically check whether the IPC
communicates with the PLC, i.e. whether
the connection still exists. For the
operability, the running PLC program must
support the watchdog function.
As the watchdog function is not supported
by the PLC sample program spsdummy.loc,
it is deactivated by the statement = 0.
QuitMode=0 If the value is 1, Windows is shut down
after the program has been quit. If the
value is zero, Windows is not shut down.
DisplayFontSize=6
HelpPath Specifies the path to the help files.