Lenze ETC Motion Control - Manual (Page 295)

ETC−MMI
"Setup" operating mode
7
7.4
l
295 EDSTCXN EN 2.0
Tool data... This key requests the current tool correction data from
the NC computer and saves them in the file
"vom_nc.wtk" in the configurations directory. The
received data is interpreted according to the
specification in the tool management and displayed in
the tool correction table.
Each defined tool can be assigned a magazine position.
It is not permissible to assign a magazine position more
than once. A tool is regarded as defined if a tool number
is entered in the "Original tool" field. A sister tool is
created by entering the number of the original tool in
the "Original tool" field of the sister tool. Data which
has already been entered for the original tool can be
adopted for the sister tool.
When a field is quit, the entered values are checked. The
field can only be quit if correct values have been
entered. When the "Original tool" and "Sister tool"
fields are changed, some of the fields are filled in
automatically.
ETCN069
Import The data from the table is adopted in the NC computer;
however, only temporarily, i.e. the information is lost
when the control system is switched off.
Import + save The data from the table is transferred to the NC
computer and saved on the PC in a file.
back... Back to the previous level.
Change positions... This key requests the current magazine data from the
NC computer and saves it in the file "vom_nc.wsk" in
the configuration directory. The received data is
interpreted according to the specification in the tool
management and displayed. The table shows the
assignment between magazine positions and the
coordinate systems. The change positions are also
entered in the table. The positions for X, Y, Z and C can
either be entered manually or determined via a teach
function. If the machine offers the possibility to move
the axes independently from softkeys, the positions can
be approached and adopted for the selected magazine
position by means of the <Position import> key. The
data is entered in the corresponding columns.
Position import The current axis positions are read as tool change
positions and entered in the table.
Import The data from the table is adopted in the NC computer;
however, only temporarily, i.e. the information is lost
when the control system is switched off.