Lenze ETC Motion Control - Manual (Page 81)

Getting started
Operation via a Lenze−HMI
Functional description HMI505 operation
2
2.15
2.15.2
l
81 EDSTCXN EN 2.0
2.15.2 Functional description HMI505 operation
In the following, the functional description of the project "ETC−Schulung des
HMI" ("ETC training of the HMI") will be briefly explained.
ƒ Selection of the Hand (Manual) and Auto operating modes
ƒ Switching the drives on and off
ƒ Error reset
ƒ Activation of the download page
ETCN048
ƒ Setting the override for manually traversing the axes
ƒ Traversing the X and Y axes in both directions
ƒ Error reset
ƒ Return to start page
ƒ Display of the axis positions
ETCN049
Start page
Manual operating mode