Lenze ETC Motion Control - Manual (Page 305)

ETC−MMI
"Programming" operating mode
ASCI editor
7
7.6
7.6.1
l
305 EDSTCXN EN 2.0
7.6.1 ASCI editor
The editor is primarily used for entering and changing CNC programs
according to DIN 66025, but also for editing any ASCII files.
ETC075
)
Note!
We recommend to operate the editor via an external keyboard.
To facilitate program creation, the CNC blocks are automatically
set in upper case letters. If you want to enter lower case letters
(e.g. for axes u, v, w), press the <Shift> key during the entry. In
comments, the editor automatically switches to the usual entry
form.
<Cursor left/right> Move cursor a character to the left/right.
<Shift>+<Cursor left/right> Highlight character to the left/right of the cursor.
<Pos1> Set cursor to beginning of line.
<End> Set cursor to end of line.
<Ctrl−Pos1> Set cursor to beginning of file.
<Ctrl−End> Set cursor to file end
<Page up> Browse up page by page.
<Page down> Browse down page by page.
<Ctrl>+<C> Copy range to clipboard.
<Ctrl>+<X> Move range to clipboard (cut).
<Ctrl>+<V> Paste contents of clipboard at cursor position.
<Ctrl>+<Z> Reset last change of a line.
<ENTER> Add new line.
<Backspace> Delete the character to the left of the cursor or marked text
block.
<DEL Delete the character to the right of the cursor or marked text
block.
Key functions