Lenze ETC Motion Control - Manual (Page 48)

Getting started
Creating a CNC sample program
Entering and saving a CNC program
2
2.10
2.10.2
l
48 EDSTCXN EN 2.0
2.10.2 Entering and saving a CNC program
We create a program for a profile with rounded reference points.
Starting point: The cursor flashes in the top right of the text editor and the
graphic area is displayed.
1. Enter the CNC program in the text editor according to the following
table:
Line Input in the text editor Meaning Display in the graphic area
1 %1 Determine program number
2 G1 F10000 Determine travelling speed
3 G17 Determine plane
4 G0 X10 Y10 Travel to starting point at
high rate creates a straight line from
the zero point to the starting
point
5 G2 X20 Y20 R10 Execute a section of the
square profile creates a quarter circle
6 G1 X30 adds a straight line
7 G2 X40 Y10 R10 adds a quarter circle
8 G1 Y0 adds a straight line
9 G2 X30 Y−10 R10 adds a quarter circle
10 G1 X20 adds a straight line
11 G2 X10 Y0 R10 adds a quarter circle
12 G1 Y10 adds a straight line to a
closed square profile
13 G0 X0 Y0 Travel to zero point at high
rate
14 M30 End of program
ETCN015
2. Press <F4> (Save as).
3. As program name, enter e.g. test.din.
4. Press <Enter>.