Lenze ETC Motion Control - Manual (Page 49)

Getting started
Creating a CNC sample program
Loading the CNC program into the control system and starting it
2
2.10
2.10.3
l
49 EDSTCXN EN 2.0
2.10.3 Loading the CNC program into the control system and starting it
Starting point: PLC program is displayed in the editor.
1. Press <F7> (Program to NC).
2. Select the program; e.g. test.din.
3. Press <Enter>.
The program is transferred to the control system ETCxC.
Starting point: The cursor flashes in the top right of the text editor and the
graphic area is displayed. In the control system, the program (e.g. test.din.)
is loaded.
)
Note!
On principle, operation of the CNC program is possible without
connected mechanics and drives and also without a PLC
program. For this purpose, the following machine constants
must be set:
ƒ MK_TEST_OHNEMECHANIK=1
ƒ MK_SPS_DUMMY=1
1. Press <S1> (Start).
The drives start and the profiles of the rectangle are executed (if the
graphic is not switched on, the numbers of the set and actual positions
change). The individual commands are shown in the lower part of the
window.
ETCN016
The drawn straight line from the zero point (0/0) to the starting point
(10/10) is now executed when the drive is also in the zero point.
Otherwise, the control system traverses the drives on a straight line from
the current point to the starting point.
2. To change the material speed, press <S6>/<S7> (Override +/−).
3. To stop the drives, press <S2> (Stop).
Load program into the control
system
Start program in the control
system