Lenze ETC Motion Control - Manual (Page 315)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
315 EDSTCXN EN 2.0
Parameter field (P field) The following applies for all entries: The <Enter> key is
used to confirm the entry, the <ESC> cancels the entry.
P field read Display the value of a parameter field. The P field
number is entered in the status line. The contents are
output in the display line. If this field is selected, the
number that was entered last is automatically offered.
A different number can be entered immediately
without having to delete the old display.
ETCN088
P field edit Change the value of the desired parameter field. Both
entries are made in the input line. For entering the
digits, the same applies as to "P field read).
Permanent display Opens a separate window with a list of 32 parameters.
They are displayed in their current version until the
dialogue window is closed again with <ESC>.
Entered P fields are permanently displayed in this
window.
The parameters are selected by selecting a position by
means of the cursor keys and opening an input window
by means of the <Space bar>. There, the desired P field
number is entered. When the window is called, the P
fields specified in the configuration file are
automatically displayed. These numbers can be
overwritten at any time.
ETCN089