Lenze ETC Motion Control - Manual (Page 297)

ETC−MMI
"Setup" operating mode
7
7.4
l
297 EDSTCXN EN 2.0
When you switch to tool management, a new vertical softkey line is shown.
Fetch tool The tool "Tx" displayed in the status fields is fetched
from the tool magazine and placed in the tool holder.
Change tool The tool currently located in the tool holder is replaced
by the tool "Tx" displayed in the status fields. The
functions of the tool change require a corresponding
PLC program (DIN program).
Deposit tool The tool "Tx" displayed in the status fields is stored in
the tool magazine.
Vertical function keys in the
Tool management menu