Lenze ETC Motion Control - Manual (Page 337)

PLC programming
CoDeSys installation
System requirements for CoDeSys V2.xx
8
8.2
8.2.1
l
337 EDSTCXN EN 2.0
8.2 CoDeSys installation
8.2.1 System requirements for CoDeSys V2.xx
ƒ Pentium processor (Pentium II, 350 MHz or higher recommended)
ƒ 32 MB RAM (64 MB recommended)
ƒ Windows 2000 or XP
ƒ MS Internet Explorer version 4.0 or higher
8.2.2 Installing software
1. Place the CoDeSys setup CD into your CD−ROM drive.
If the autostart feature for the CD−ROM drive has been enabled in
Windows, setup will start automatically.
2. If setup does not start automatically:
– Select the menu item "Run" from the start menu.
– Enter the drive letter of your CD−ROM drive followed by "setup.exe"
(e.g. "d:\setup.exe") into the command line and confirm with "OK".
3. When selecting the target directory please create a new directory
"CoDeSys" under "c:\program files\Lenze\ETC".
4. Follow the instructions of the setup program.
5. Change the installation path to "c:\program
files\lenze\etc\CoDeSys2".
(
Stop!
The file "codesys.ini" in the installation directory may be
write−protected after installation from CD. The write−protection
must be cancelled, otherwise the CoDeSys settings will not be
saved.