Lenze ETC Motion Control - Manual (Page 283)

ETC−MMI−Gateway
Mmigtway.ini
6
6.4
l
283 EDSTCXN EN 2.0
6.4 Mmigtway.ini
In the file "mmigtway.ini", the current configuration of the gateway is saved.
In the [Connections] sections, general information of the gateway is saved.
The following key variables are defined:
ƒ UdpConns = number of UDP connections (number of ETCHCs)
ƒ PciConns = number of PCI connections (number of ETCPCs)
ƒ DemoConns = reserved for simulated connections
In the [Options] section with the key variable "AutoClose", you can
determine whether the gateway is to be closed automatically when there is
no connection to an application.
The key variables defined in the [Traces] section are the active traces. If the
value of the variable is non−zero, the corresponding trace information is
logged in the file "mmigtway.trc". (
¶ 281).
For each connection, another section is created. "*" is the index of the
connection:
ƒ [UdpConn*] − for UDP connection (ETCHC)
ƒ [PCIConn*] − for PCI connection (ETCPC)
ƒ [DemoConn*] − for demo connection
The names of the connection, the communication parameter (IP address for
UDP connections, index for PCI cards) and the PC disk path are saved under
the key variables "Name", "Param", "PcDir".
[Connection] section
[Options] section
[Traces] section
Sections of the connections