Lenze ETC Motion Control - Manual (Page 86)

Getting started
Updating the firmware of the ETCHx in the "Standalone" operating mode
Updating the firmware
2
2.16
2.16.3
l
86 EDSTCXN EN 2.0
Command Meaning
ver Shows the versions of the boot loader and the currently loaded firmware.
sz [file name] Sends the currently loaded firmware under the specified name to the PC via
Z modem.
rz When "Dateien senden" ("Transmit files") is selected, this command is sent
implicitly by the connected terminal program to the control system. It is
used for the transmission of firmware or boot loader to the control system.
For the transmission, the "ZMODEM" protocol must be selected.
quit Quits the boot monitor and starts the loaded firmware.
reset Resets the control system.
help Shows the commands of the boot monitor.
Important commands of the
boot monitor