Lenze ETC Motion Control - Manual (Page 67)

Getting started
Creating a PLC sample program
Starting and configuring the PLC sample program
2
2.12
2.12.2
l
67 EDSTCXN EN 2.0
The output O_ToolDown is reset and a timer of 5 s is started. If the input
I_ToolUp is set within the next 5<s, the function is switched, otherwise an
error message is displayed.
ETCN033
If no I/O modules are connected to the control system, the visualisation can
be used.
ETCN034
"DRIVES ON/OFF" switches the drives on and off. "Tool_up" and
"Tool_down" are the switches that are to be activated.
M15