Lenze ETC Motion Control - Manual (Page 330)

ETC−MMI
Appendix
Configuration file (DELPHMMI.INI)
7
7.8
7.8.3
l
330 EDSTCXN EN 2.0
Description Term Section
[startup] In the [startup] section, additional
procedures during the startup of the HMI
software are determined.
dinLoad=1 This Boolean value defines (=1) whether
after a complete (!) download of the NCR
the automatic DIN program that was used
last is loaded back into the control system
and prepared for the program start.
dinFile=c:\prog\beispiel.din The name of the automatic DIN program
that was used last. This entry is updated by
the HMI.
StartPrg= Enter the number of the program (1 ...
7999) that is always to be started. If no
number or zero is entered, the program
that was loaded last is started.
AxeKorr= During program start, a leadscrew pitch
correction file is transferred.
logo=
c:\bilder\logo.bmp Specifies a bitmap that is to be displayed. If
no file is specified, the default bitmap of
the application is displayed.
wait=1 The integer value (in seconds) determines
how long the application is to wait while
the logo is being displayed (>0), until it
continues to start up the system. The value
is limited to the entry under the term
"time".
time=5 Specifies the period of time (in seconds)
that the logo is displayed. If the value is 0,
the display of the logo is suppressed.
Top=10 Defines the Y coordinate of the left upper
edge of the image in the display.
left=10 Defines the X coordinate of the left upper
edge of the image in the display.
[e/a anzeige]
Textbasisnr=30000000 Basic number in the file Sprache.txt where
the I/O signal texts start.
Separate_karten_texte=1 1: separate texts for each module
0: the texts of module 1 are used for all
modules
[language]
Text0=Sprache.txt
Text1=SPS.txt If the entry Language in the [Config]
section remains empty, the [language]
section is used. Texts of several files are
defined. Texts can, for example, be
maintained by the MMI developer, others
by the PLC programmer and others by the
end customer. It must be ensured that the
text numbers are strictly assigned.