Lenze ETC Motion Control - Manual (Page 320)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
320 EDSTCXN EN 2.0
Start Starts the selected program or blockwise processing in
single block operation.
Stop Immediately stops program execution. All axes are
stopped with the set deceleration ramps. After a restart,
processing is started again.
Travel+ Manual traverse key for positive axis direction of the
selected axis.
Travel− Manual traverse key for negative axis direction of the
selected axis.
Axis Select the axis to be traversed. Alternatively, the axis
can be selected by means of the <Cursor> keys.
Override+ Increase the axis or path speed of the selected axis (in
percent of MK_VMAX). Over 10%, the value is changed
in steps of 10%, below 10% in steps of 1%.
Override− Reduce the axis or path speed of the selected axis (in
percent of MK_VMAX). Over 10%, the value is changed
in steps of 10%, below 10% in steps of 1%.
Vertical function keys