H3C Technologies H3C Intelligent Management Center - Manual (Page 123)

114
Figure 17 Network topology—Example 2
Task analysis
To execute this scenario, the network administrator at the headquarters should perform the following
tasks:
1. Add virtual CPEs to BIMS.
2. Import software to be deployed to the branch CPEs to BIMS.
3. Create an automatic deployment task and bind the CPE software to the virtual CPEs.
4. Create configuration files in USB flash drives and distribute the USB flash drives to branch network
administrators.
After obtaining a USB flash drive, a branch network administrator performs the following tasks:
1. Specify the username and password for accessing the Internet in the configuration file in the USB
flash drive, and rename and save the file to a computer.
2. Copy the new file to the root of the USB flash drive.
3. Plug the USB flash drive into a CPE, and then power on the CPE.
The CPE then automatically accesses BIMS and installs the CPE software.
BIMS operations
The following sections describe the operations you must perform in BIMS for this example.
Adding virtual CPEs to BIMS
When you add virtual CPEs, choose the ACS Username authentication type. Configure only one ACS
username for the CPE at each branch.