Recent 10 unrecovered alarms, Available actions, Apply options – H3C Technologies H3C Intelligent Management Center User Manual
Page 22
13
•
Latest Available Software for Upgrade—The latest available software version that can be used for
upgrade.
If you want to check more details about the configuration backup history and the software deploy history,
click Configuration History on the upper right corner of the Configuration Management pane. For more
information, see "
Managing backup history records
Recent 10 unrecovered alarms
The ten latest unrecovered alarms are displayed in the Recent 10 unrecovered alarms pane. You can
check the alarm level, description, and alarm raised time. If you want to check more alarms, click the
more on the upper right corner of the Recent 10 unrecovered alarms pane. For more information about
BIMS alarms, see "
Available actions
The Action pane contains the following items:
•
Refresh—Refresh the page.
•
Delete—Delete the associated CPE device.
•
Synchronize—Synchronize the configuration information shown on BIMS with the CPE device.
•
IP Ping Test—Launch an IP ping test to test the connectivity between the CPE and other devices. This
action is not supported for CPEs in device mode.
a.
On the IP Ping Test page, configure the following parameters:
−
Timeout—Specify the response timeout timer in seconds. Connectivity is not available if no
response has been received before the timer expires.
−
IP Packets Size—Specify the size of the ICMP packets.
−
Number—Specify the number of IP ping tests.
−
DSCP—Specify the DSCP value in the ICMP packets.
−
Host—Specify the destination IP address. By default, this field displays the IP address of the
ACS.
−
Interface—Specify the Layer 3 interface that the CPE uses to communicate with the
destination device.
b.
Click Test to launch the test process.
The test results appear on the IP Ping Test Results page.
•
Open Web Manager—Click to open the CPE web manager.
Apply options
The Apply pane contains entries for you to modify CPE attributes. A CPE operating in device mode does
not support the following entries:
•
WAN DSL Link.
•
WAN IP Connection.
•
WAN PPP Connection.
•
Remote Reboot.