Adding a check task – H3C Technologies H3C Intelligent Management Center User Manual
Page 136
127
3.
On the Add Compliance Policy page, enter the policy name as interface link-protocol check.
4.
For the description, enter Check the link-protocol mode in all interfaces.
5.
Click Add Rule at the top of the Rule List pane.
6.
On the Add Rule page, complete the parameters as follows:
{
Name: link-protocol
{
Severity Level: Major
{
Check Type: Interface
{
Start Identifier:
interface*
{
End Identifier:
#
{
Check Target: Latest backup running configuration
{
Vendor: All
{
CPE Class: 12508(HP)
{
Description: Check the link-protocol of all interfaces
{
Recover: No
{
Rule Type: Basic
{
Match Mode: Strict Match
{
Match Patterns: link-protocol PPP
7.
Click OK.
8.
Go back to the Add Compliance Policy page and test the added rule:
a.
Click the Test icon in the Test column of the link-protocol rule.
b.
On the Test Rule page, enter
link-protocol PPP
into the Test Content text box, and then click
Test.
A message saying "Test content matches rule link-protocol." appears, which means the rule
link-protocol passed the test.
9.
Go back to the Add Compliance Policy page, and then click OK.
Adding a check task
1.
Click Service > BIMS > Compliance Center > Check Task.
2.
On the Check Task page, click Add.
3.
On the Add Check Task page, complete the parameters as follows:
{
Task Name: link-protocol check
{
Severity Level: Major
{
Execute Task: Immediately
{
Description: Check the link-protocol of all interfaces
4.
In the Compliance Policy List pane, delete the policy you do not need.
5.
Click Select CPE Class to activate the CPE class selecting options in the Select CPEs Or CPE Classes
pane.
6.
Click Select Class.
7.
On the Select CPE Class page, select the check box to the left of 12508(HP), and then click OK.