H3C Technologies H3C Intelligent Management Center - Manual (Page 30)

21
Two ways to open the data model page are:
• Configuring the data model over single a CPE by clicking the Data Model icon on the CPE Details
page. There is no need to select a CPE in this mode, you only need to select a target operation, and
then the results are displayed on the Operation Result pane.
• Configuring the data model in batches.
To configure the data model in batches:
1. Click Service > BIMS > Resource Management > Batch Operate.
2. On the Batch Operate page, click Data Model.
The Data Model page appears.
3. In the CPE List pane, click the Select CPE icon .
4. On the CPE List page, specify the querying conditions, and then click Query, or click Query directly
to query all CPEs.
The available CPEs appear under the CPE List pane of the Data Model page.
5. Select one or more target CPEs by clicking the associated check boxes, and then select a target
parameter from the InternetGatewayDevice folder.
6. Right-click the parameter, and then, on the operation menu, complete the following:
{
Get Parameter Values—Select to get the parameter value information from the CPE.
{
Get Parameter Attributes—Select to display the parameter attributes information from the CPE.
{
Set Parameter Values—Enter the parameter values in the Operation Result pane, and then click
Set Parameter Values to apply them immediately.
{
Set Parameter Attributes—Enter the parameter attributes in the Operation Result pane, and
then click Set Parameter Attributes to apply them immediately.
{
Parameter Information—Select to display the parameter details in the Operation Result pane.
All operation results are displayed in the Operation Result pane.
Managing a CPE Interaction Log
An Interaction Log is a system record generated automatically by BIMS. It records the communication
history between BIMS and CPEs, including CPE request message, file upload notifications, and other
configuration messages.
Viewing a CPE Interaction Log list
1. Click Service > BIMS > Resource Management > CPE Interaction Log.
All interaction logs are displayed in the CPE Interaction Log list, which contains the following
information.
{
CPE Name—The CPE name, which is set to OUI + Serial ID by default. You can customize this
during the CPE adding procedure. You can click this link to open the specific CPE Details page.
{
OUI—The organizationally unique identifier number of the vendor.
{
Serial ID—The CPE serial ID number.
{
IP Address—The IP address of the CPE device.
{
Operation Time—When the interaction log occurred.