Epson WorkForce AL-MX300DN - Manual (Page 137)

Determines the amount of memory to be used for receiving data and printing data. If Maximum is
selected, more memory is allocated for receiving data. If Minimum is selected, more memory is
allocated for printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five seconds then turn
it back on. Or, you can perform a Reset All operation, as explained in “Reset Menu” on
page 140.
❏ Resetting the printer erases all print jobs. Make sure the Data light is not flashing when you reset the
printer.
Network Menu
See the Network Guide for each setting.
USB Host Menu
This menu allows you to use the USB Host printing function. For instructions on using the function,
see “Printing Directly from a USB Memory” on page 75.
Item Settings (default in bold)
USB Host * On, Off
* After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again. While it is
reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is
turned on again.
USB Host
Enables you to print directly from a USB memory via a USB Host interface.
E-mail Server Settings
Item Settings (default in bold)
Auth Method Off, POP before SMTP, SMTP Auth *1
Auth Account *2 Up to 30 characters
AL-MX300 Series User's Guide
Using the Control Panel 137