Epson WorkForce AL-MX300DN - Manual (Page 206)

! Caution:
❏ Unless specifically instructed in this guide, be careful not to touch the fuser, which is marked
with a caution label, or the surrounding areas. If the printer has been in use, the fuser and the
surrounding areas may be very hot. If you must touch one of these areas, wait 40 minutes to
allow the heat to subside before doing so.
❏ Do not insert your hand deep into the fuser unit as some components are sharp and may cause
injury.
Paper Jam B (Cover B)
1. Open cover B.
2. If there is any jammed paper, remove it gently with both hands. Be careful not to tear the jammed
paper.
AL-MX300 Series User's Guide
Troubleshooting 206