Epson WorkForce AL-MX300DN User Manual
Page 176
This message indicates that the photoconductor unit is near the end of its service life. You can
continue to print until the Replace Photoconductor message appears. To clear this warning
message and continue printing, select Clear All Warnings from Reset Menu in the Common
Settings
menu. For instruction about accessing the control panel menus, see “Accessing the each
Photoconductor Trouble
There is a problem with the photoconductor unit. Remove the photoconductor unit and reinsert it. If
that fails to clear the error, replace the photoconductor unit with a new one. For details about
replacement, see the instructions that come with the photoconductor unit.
Please choose the e-mail address.
An e-mail address is not specified. Press the F1 button to select E-mail, press the F1 button again to
select Address, and then specify a destination.
Please choose the folder.
A destination folder is not specified. Press the F1 button to select Save to and specify a destination.
Specify the address
The printer is ready to send a fax. Enter a recipient fax number using the numeric keypad or specify an
address from the speed-dial list.
Print Overrun
The required time to process the print data exceeded the print engine speed because the current page is
too complex. Select Close to resume printing or cancel the print job. To cancel the print job, see
“Canceling a Print Job” on page 72. If this message appears again, select On as the Page Protect
setting in the control panel’s Setup Menu.
If you continue to receive this message when printing a particular page, try simplifying the page by
limiting the number of graphics or reducing the number and size of fonts.
Printer Error Unable to Copy/
Printer Error Unable to Print
An error occurred on the printer. Turn off the printer, wait several minutes and then turn it on again.
RAM CHECK
The printer is checking the RAM.
AL-MX300 Series User's Guide
Using the Control Panel 176