Epson WorkForce AL-MX300DN - Manual (Page 30)

d Setting button Use this button to switch to the setup mode.
e Mode buttons/LEDs (Green) Use these buttons to switch to the corresponding mode.
f LCD panel Displays printer status messages and control panel menu settings.
g OK button Use these buttons to access the control panel menus, where you can make
printer settings and check the status of consumable products. For instructions
on how to use these buttons, see “Using the Control Panel” on page 125.
Up button
Right button
Down button
Left button
h Onhook button Use this button to switch between on-hook and off-hook.
i Redial/Pause button Use this button to redial to the same fax number called previously or to insert a
pause (-) when dialing a number.
j Address-book button Use this button to display the information registered in the address list.
k Power Saving button/LED
(Green) Use this button to enter the power saving mode. This mode is canceled when
the button is pressed again. This button lights up when the printer is in the sleep
mode (the deep sleep mode).
l Stop button When the printer is printing, pressing this button stops the printing.
m Reset button Use this button to reset the selected setting item or mistakenly entered values
to the default value. Also, use this button to delete one character from the
entered data when entering a recipient fax number in Fax mode.
n Start button Use this button to start a copy, scan, or fax transmission.
o Numeric key pad Used to enter the number of copies or a zoom value in Copy mode. Also, enters
numeric values, such as the Time Setting in Setup Menu.
p Clear button Use this button to clear the number of copies or delete a character when
entering a text or numbers.
q Status button Use this button to check the status of print, copy, and fax jobs, the usage of
consumable products, and any warnings.
r Data light (Green) On when print data is stored in the print buffer (the section of printer memory
reserved for receiving data) but not yet printed.
Flashes when the printer is processing data.
Off when no data remains in the print buffer.
s Error light (Orange) On or flashes when an error has occurred.
t Return button Use this button to return to a higher hierarchical level while doing settings.
AL-MX300 Series User's Guide
Getting to Know Your Printer 30