Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 107)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-87
8. Click OK to close the TCP/IP dialog box.
9. Click Save to open the Save Setup dialog box.
10. Key in >defaultb.stn< in the File name field and click Save.
11. Click Yes to replace the existing file, if applicable.
12. Click Cancel at the Unable to connect prompt, if applicable.
13. Click Station
⇒
Setup to call up the Station Setup dialog box.
14. Click the down arrow button in the Server Connection field and
select Network (TCP/IP).
15. Click Setup in the Server Connection field to call up the
TCP/IP Setup dialog box. Make these entries to have the Station
point to the SERVERA (PLX1A) node:
a. Key in the name or IP address of the SERVERA (PLX1A) node
specified in the Hosts file in the Server Name field.
The PLX1A is the default Server name assigned by the factory. It
is used for example purposes only.