Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 41)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-21
1. If the following pre-upgrade directories exist from a previous Server
migration, delete them:
•
C:\Honeywell\ips.preupgrade
•
C:\Honeywell\server.preupgrade
2. Insert the ProcessLogix R320.0 software CD into the CD-ROM
drive.
3. Click Start
⇒
Run.
4. Key in this path location in the Open entry field or use Browse to
navigate to the setup.exe file on the CD.
>D: (or your CD-ROM drive letter)\SETUP.EXE<
5. Click OK to launch the software setup application.
6. Click the ProcessLogix Server option and click Next.
7. At the ProcessLogix R320.0 Welcome window, click Next.
8. Click Yes to accept the license agreement.
9. At the Before installing window, click Yes.
Installing RSLinx
1. At the RSLinx Welcome window, click Next.
2. Click Yes to accept the license agreement.
3. At the Verify System Files window, click Next.
IMPORTANT
You must have either a 1784-PCIC or Ethernet card
installed in your ProcessLogix Server to install R320.0.
TIP
If a Read only File Detected message appears during
software installation, check the Don’t display again
checkbox and click Yes to acknowledge the message.