Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 139)

Publication 1757-IN032B-EN-P - April 2001
Full PC Software Installation Procedures 3-11
8. Click Test and click OK to invoke a sample screen.
•
If the sample screen displays correctly, click Yes.
•
If it does not display correctly, click No. Change the Desktop
Area, Color Palette, or Refresh Frequency and repeat this step to
correct the problem.
9. Close the Display Properties window. Close the Control Panel.
10. Add any other required drivers at this time. For example, Tape
Drive, Sound Card, etc.
Configuring System Properties
Use the following procedure to configure the virtual memory.
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the System icon.
3. Click the Startup/Shutdown tab.
4. Check the boxes:
•
Write event to the system log
•
Write debugging information to:
5. Click the Performance tab.
6. Set Application Performance Boost to None.
7. In the Virtual Memory group, click Change.
8. Key in >400< in the Initial Size (MB) field, press <tab> and key
in >400< in the Maximum Size (MB) field.
9. Click Set to apply these changes.
10. Click OK to close the Virtual Memory dialog box.
11. Close the System Properties dialog box.
12. Click Yes to restart the PC.