Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 28)

Publication 1757-IN032B-EN-P - April 2001
1-8 System Software Upgrade Procedures
Stopping ProcessLogix
Applications and Services
Use the following procedure to exit all ProcessLogix applications and
stop all ProcessLogix services.
1. Exit all running ProcessLogix applications, such as Control Builder,
Station, and Network Tools (NTOOLS).
2. Stop the following ProcessLogix services through the Services icon
in Control Panel. When finished, close the Services dialog box.
•
ProcessLogix ER Replicator (redundant SERVERB node only)
•
ProcessLogix ER Server
•
ProcessLogix System Repository
•
ProcessLogix Control Data Access Server
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
IMPORTANT
If you have redundant servers, you must complete this
procedure on the SERVERB node first. Then complete
the entire procedure again for the SERVERA node.
TIP
Some software services may interact. For example,
stopping the ProcessLogix System Repository
automatically stops the ProcessLogix Control Data
Access Server, if it is running.
Observe the on-screen prompts for details.