Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 9)

Publication 1757-IN032B-EN-P - April 2001
Table of Contents v
Configuring the ControlNet Supervisory Network . . . . . 3-31
Updating the 1784-PCIC Network Address . . . . . . . . . . 3-32
Configuring RSLinx Drivers for Ethernet
Supervisory Network . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-33
Upgrading Hardware Component Firmware. . . . . . . . . . . . 3-34
Making Post ProcessLogix Software Installation
Checks for a Non-redundant Server . . . . . . . . . . . . . . . . 3-34
Checking Control Builder Operation and Logging On . . 3-34
Enabling the ProcessLogix OPC Server . . . . . . . . . . . . . 3-34
Backing Up a ProcessLogix Server Hard Drive to Tape . 3-34
Creating the Emergency Repair Disk . . . . . . . . . . . . . . 3-35
Installing ProcessLogix Client Software on a Clean PC . . . . 3-35
Checking Required System Settings . . . . . . . . . . . . . . . 3-35
Installing ProcessLogix Client software . . . . . . . . . . . . . 3-35
Verifying ProcessLogix Client Installation. . . . . . . . . . . . . . 3-36
Setting Up a ProcessLogix Client
with a Non-redundant Server . . . . . . . . . . . . . . . . . . 3-36
Setting up a ProcessLogix Client
with Redundant Servers . . . . . . . . . . . . . . . . . . . . . . 3-36
Checking Control Builder Operation and Logging On . . 3-36
Creating an Emergency Repair Disk . . . . . . . . . . . . . . . 3-36
Chapter 4
Completing ProcessLogix Install on a Redundant Server Pair
and Adding Redundancy to R320.0
Non-Redundant Server Systems . . . . . . . . . . . . . . . . . . . . 4-1
Changing Hosts File Entries . . . . . . . . . . . . . . . . . . . . . . 4-1
Changing TCP/IP address on a Secondary
Server (SERVERB) Node . . . . . . . . . . . . . . . . . . . . . . . 4-4
Changing the Computer Name . . . . . . . . . . . . . . . . . . . . 4-5
Updating the Registry . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
Changing the ProcessLogix License . . . . . . . . . . . . . . . . 4-6
Re-installing ProcessLogix Engineering Tools . . . . . . . . . 4-6
Configuring RSLinx Drivers for ControlNet
Supervisory Network . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
Installing the 1784-PCIC Driver . . . . . . . . . . . . . . . . . . . 4-9
Updating the 1784-PCIC Card Firmware . . . . . . . . . . . . 4-10
Configuring the ControlNet Supervisory Network . . . . . 4-10
Updating the 1784-PCIC Network Address . . . . . . . . . . 4-11
Configuring RSLinx Drivers for Ethernet
Supervisory Network . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-12
Restarting Redundant Servers . . . . . . . . . . . . . . . . . . . . . . 4-13
Setting up Secondary Server (SERVERB) node . . . . . . . . . . 4-13
Setting Up Primary Server (SERVERA) Node. . . . . . . . . . . . 4-19
Upgrading Hardware Component Firmware. . . . . . . . . . . . 4-20