Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 21)

1 Publication 1757-IN032B-EN-P - April 2001
Chapter
1
System Software Upgrade Procedures
Preparing for a
ProcessLogix Software
Upgrade
•
Refer to Installing ProcessLogix Client Software on page 1-73 to
upgrade the Client software on a networked ProcessLogix
Client system.
•
Refer to Full PC Software Installation Procedures on page 3-1 to
install ProcessLogix software on a clean PC.
Things to consider before upgrading
ATTENTION
!
This section assumes that you are currently running
ProcessLogix software version R300.1 or 310.0 and
Service Pack 5 for Windows NT 4.0. The tasks
associated with upgrading from an earlier release are
beyond the scope of this document.
If you are migrating a system from R300.0 or earlier,
you must upgrade to R300.1 or R310.0 before
proceeding with the R320.0 upgrade.
Refer to the documentation supplied with R300.1 or
R310.0 ProcessLogix software for instructions on
upgrading from an earlier release to R300.1 or R310.0.
ATTENTION
!
Be certain that your process is off control before you
begin any upgrade procedure. This means the
1757-PLX52 should be in the Idle state.
ATTENTION
!
Before upgrading to this release, be certain that the
ProcessLogix user accounts exist and are set up
correctly. Refer to Setting Up User Accounts on
page 5-27.