Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 93)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-73
Installing ProcessLogix
Client Software
Two levels of the ProcessLogix Client software installation are available:
•
Operator Workstation
•
Engineering Workstation
Operator Workstation allows remote connections to the ProcessLogix
Server.
Engineering Workstation has all the functionality of the Operator
Workstation but also includes the ProcessLogix Engineering Tools. From
the Engineering Workstation, an engineer using Control Builder can
remotely access and modify the 1757-PLX52 ERDB database.
Configuring an Operator
Workstation
IMPORTANT
The ProcessLogix Server(s) must be upgraded before
the ProcessLogix Client upgrade is performed.
ATTENTION
!
This procedure assumes that you are installing software
on an Operator Workstation that can be used in an
R320.0 ProcessLogix system. This means that the
Operator Workstation must be running on a system
with Windows 95,98, or NT 4.0 with Service Pack 6a
installed.
Navigate in Knowledge Builder to Server and Client
Installation Guide
⇒
Setting up ProcessLogix Client PCs
for details on installing a Windows 95 or 98 operating
system on an Operator Workstation.
Refer to Configuring an Engineering Workstation on
page 1-78 to install the Engineering version of
ProcessLogix Client software.
ATTENTION
!
If you are installing on Windows 95 or 98 and you
encounter errors, call Rockwell Automation Technical
Support. Refer to Rockwell Automation Technical
Support in the Preface.