Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 187)

1 Publication 1757-IN032B-EN-P - April 2001
Chapter
5
Supplementary Procedures
Launching ProcessLogix
Knowledge Builder
You can call up Knowledge Builder through the Help menu in the
Control Builder application. Knowledge Builder can also be accessed
through the main Programs menu as follows:
1. Click Start
⇒
Programs
⇒
Performance Support Tools
⇒
Knowledge
Builder
⇒
Knowledge Builder to launch the application.
2. Once you launch Knowledge Builder, click Help for complete
instructions.
Cancelling a Software
Component Installation If a problem occurs during the installation routine, use the general
procedure that follows to cancel the installation of the given component.
1. Press F3 to open the Exit Setup window.
2. Click Exit Setup.
3. Try to install the given component or all components again.
If you are still experiencing problems, Refer to Rockwell
Automation Technical Support on page Preface-3 for information
on how to contact us.
Removing ProcessLogix
Software Components
IMPORTANT
To view the online documentation called Knowledge
Builder, you need the Microsoft Internet Explorer
version 5.01 HTML browser installed on your PC.
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
Refer to Stopping ProcessLogix Applications and
Services on page 1-8.