Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 196)

Publication 1757-IN032B-EN-P - April 2001
5-10 Supplementary Procedures
11. Select File
⇒
Import.
12. In the Import window, verify that the directory path is
C:\Honeywell\TPS50\Ixport\.
This directory should contain the set of files exported during the
migration process. Each function block in the exported database
should have a corresponding entry in the dialog’s object list.
13. Check the Import CEE assignments checkbox.
14. Click Select All.
The Point Name field will now contain the names of the blocks to
be imported.
15. Click Import.
Wait while the tool imports all of the blocks in the database and
assigns them to the controllers. This process may take considerable
time to complete, depending on the size of the database.
16. When done, view the Errors box to verify there were no serious
errors, then click Close.
The list of errors shown in this dialog box is saved in the
IXP_log.txt file located in the C:\ErrorHandling directory.
17. Close Control Builder.
Manual System
Backup/Restore
Procedures Backing Up a ProcessLogix Server to Tape
Refer to Backing Up a ProcessLogix Server to Tape on page 1-6.
Restoring a ProcessLogix Server System From a Backup Tape
Use the following procedure to restore the R320.0 ProcessLogix Server
system previously backed up to tape as outlined in the previous
procedure. This procedure assumes that you have replaced the original
hard drive with an equivalent one.
1. Refer to Installing Windows NT on page 3-1 to install the Windows
NT 4.0 Workstation operating system.