Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 82)

Publication 1757-IN032B-EN-P - April 2001
1-62 System Software Upgrade Procedures
Making Post ProcessLogix
Software Installation
Checks for a Redundant
Server Pair Things to Check after the Upgrade
The following table summarizes some items that should be checked
before you begin operating your upgraded ProcessLogix system.
Creating the Secondary ERDB
After updating the 1784-PCIC or Ethernet card (on SERVERA and
SERVERB), complete the following procedure on SERVERB only:
1. Click Start
⇒
Programs
⇒
ProcessLogix Engineering Tools
⇒
DBADMIN.
2. Click Tools
⇒
Create a New Replica.
a. Click OK to Make Replica of ERDB at the Primary Server.
b. If prompted to stop the ER Replicator service, click Yes.
c. If prompted to overwrite any existing files, click Yes.
4. Click OK at Stopping ER Replication Service.
The replicate window appears:
Created Secondary ERDB Successfully at:
\\severname\Hybrid\System\ER\erdb_b.mdb
Check this. Because.
Station
Configuration File The original station.ini file is renamed old_station.ini and is
replaced by a new station.ini in the
C:\WINNT directory. Any
changes made to the original file (old_station.ini) need to be made
to the new file (station.ini).
The old default.stn file in the C:\Honeywell\client\station directory
will be overwritten. Any changes made to the original file will need
to be made to the new file.
Station Menu A new Station menu (menu.txt) is installed. This means any
configurations made to the original Station menu will be lost and
will need to be reconfigured for the new Station menu through
Station.
TIP
If the File Already Exists window appears, click OK to
replace it with a new replica file.