Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 174)

Publication 1757-IN032B-EN-P - April 2001
4-10 Additional Redundant Server Procedures
7. In the Configure Drivers dialog box, you should see AB_PCIC-1
listed in the Configured Drivers list with the status running. If the
AB_PCIC-1 driver status is not running, call Rockwell Automation
Technical Support. Refer to Rockwell Automation Technical
Support in the Preface.
8. Click Close to close the Configure Drivers dialog box.
9. Close RSLinx.
Updating the 1784-PCIC Card Firmware
Refer to Updating the 1784-PCIC Card Firmware on page 3-26.
Configuring the ControlNet Supervisory Network
1. Restart SERVERB.
2. On SERVERB, click Start
⇒
Run.
3. Key in this command in the Open entry field:
>ntools -25 -c -nl -pit -pg -u<
and click OK to launch Network Tools.
4. Click OK to acknowledge the warning about monitoring through
Control Builder.
5. Click Resume to initiate network scan.
IMPORTANT
Be certain to update the 1784-PCIC firmware for both
SERVERA and SERVERB.