Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 76)

Publication 1757-IN032B-EN-P - April 2001
1-56 System Software Upgrade Procedures
4. Click the 1784-PCIC(S) for ControlNet devices selection in the
Available Drivers list box and click Add New to call up the Add
New RSLinx Driver dialog box.
5. Click OK to accept the default name AB_PCIC-1 for the driver.
6. In the Configure 1784-PCIC(S) window, enter the following:
•
Serial Number(hex): This value is read from the 1784-PCIC card
and does not change.
•
Network Address(dec):
– For SERVERA change the default of 99 to 20
– For SERVERB change the default of 99 to 19
7. Click OK to close the dialog box and start the 1784-PCIC driver.
8. In the Configure Drivers dialog box, you should see AB_PCIC-1
listed in the Configured Drivers list with the status running. If the
AB_PCIC-1 driver status is not running, call Rockwell Automation
Technical Support. Refer to Rockwell Automation Technical
Support in the Preface.
9. Click Close to close the Configure Drivers dialog box.
10. Close RSLinx.
IMPORTANT
Whenever the 1784-PCIC Network Address is changed,
the 1784-PCIC driver must be stopped and restarted to
complete the change.