Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide User Manual
Page 168
Publication 1757-IN032B-EN-P - April 2001
4-4 Additional Redundant Server Procedures
3. Click File
⇒
Exit and click Yes to save the Hosts file.
4. Repeat Step 1 to Step 3 for each Server node in your system.
Changing TCP/IP address on a Secondary Server (SERVERB) Node
If you need to change the TCP/IP address on SERVERB to agree with
Hosts file entries, do the following:
1. Click Start
⇒
Settings
⇒
Control Panel.
2. Double-click the Network icon.
3. Select the Protocols tab.
4. Select TCP/IP Protocol and click Properties.
5. Enter the TCP/IP address.
IMPORTANT
For information about the required operator actions
for the setup of fast failover, navigate in Knowledge
Builder to Server/Client Configuration
Guide
⇒
Configuring and Monitoring Redundant
Server System
⇒
Server Redundancy Fast Failover
Configuration topic for HOSTS file and redundant
hardware build details.
TIP
Networked PCs must have unique addresses. For
example, if the address for SERVERA is 192.168.0.1,
you could change the SERVERB address to
192.168.0.2.