Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 134)

Publication 1757-IN032B-EN-P - April 2001
3-6 Full PC Software Installation Procedures
This will specify whether this PC will participate in a network.
2. Click Next.
3. Setup prompts you to identify the type of network card installed in
your PC.
a. Select Start Search if you want Windows NT to automatically
detect the card installed in your PC.
If the detected card is incorrect, or no card is detected, click
Select from list and select the correct network card from this list.
b. If you do not have a network card, click Select from list and
select MS Loopback Adapter from this list.
4. Click Next.
5. Select the TCP/IP protocol as the network protocol to be used
across the network.
6. Click Next.
7. Click Next to install the default services.
8. Click Next to install networking components.
9. If the MS Loopback Adapter is being installed, accept the frame
type of 802.3 in the MS Loopback Adapter Card Setup dialog box.
10. Click No in response to the prompt for whether there is a DHCP
Server on the network, unless advised otherwise by your network
administrator.
TIP
It may be necessary to insert a manufacturer’s
diskette to install the NIC card in your system. If
so, click Have Disk and follow the manufacturer’s
instructions.
IMPORTANT
If Setup prompts you for the network card’s IRQ and
address settings, be sure the settings match the card’s
dipswitch configuration.