Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 109)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-89
21. If you have redundant LANs, you must repeat Step 3 through
Step 20 to set up files for the second LAN using the name or IP
address of the SERVERA and SERVERB nodes specified in the
Hosts file for the second LAN
.
22. Click Station
⇒
Exit.
23. Click OK to exit Station.
Checking Control Builder Operation and Logging On
Use the following general procedure to log on and check Control Builder
operation on a ProcessLogix Engineering Workstation.
1. Click Start
⇒
Programs
⇒
ProcessLogix Engineering
Tools
⇒
Control Builder.
2. In the Login dialog box, make these entries:
a. Key in >mngr< as the default User Name.
b. Key in >mngr1< as the default Password.
c. Key in the name of the appropriate Server node in the Server
Name field.
3. Click OK.
Creating an Emergency Repair Disk
Refer to Creating an Emergency Repair Disk on page 1-43.
EXAMPLE
For example, the Secondary Server (SERVERB) name
would be PLX1B1 based on a Server name of PLX1B
in Step 7 and the Primary (SERVERA) name would
be PLX1A1 based on a Server name of PLX1A in
Step 15.
Refer to the Server/Client Configuration Guide in
Knowledge Builder for more information.
The Server names used are for example purposes only
and must not be used in place of your actual Server
names.