Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 33)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-13
Upgrading Data Access
Components
For your convenience, we have included MDAC 2.1 on the
ProcessLogix R320.0 software CD. Use the following procedure to
install MDAC 2.1 on the PC.
1. Insert the ProcessLogix R320.0 software CD into the CD-ROM
drive.
2. Click Start
⇒
Run.
3. Key in this path location in the Open entry field or use Browse
to navigate to the mdac_typ.exe file on the CD.
>D: (or your CD-ROM drive letter)\Mdac21\Mdac_typ.exe<
4. Click OK to launch the MDAC 2.1 setup.
5. Click Yes to accept the license agreement.
6. Click Continue.
7. At the MDAC 2.1 Setup window, click to start the
installation.
8. At the Restart Windows dialog box, remove the CD and click
Restart Windows for the changes to take effect.
If you don’t get a Restart Windows dialog box, click OK, remove
the CD and manually restart the PC for changes to take effect.
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
Refer to Stopping ProcessLogix Applications and
Services on page 1-8.