Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 63)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-43
7. At DOS prompt, key in:
>cd\Honeywell\server\run<
and press <Enter>.
8. Key in this command:
>hscopcserv.exe /r /s<
and press <Enter>.
9. Key in this command:
>copy d:\server-client\hci\gopc.dll “c:\Program Files\Honeywell\TPS\hci”<
and press <Enter>.
10. At DOS prompt, key in:
>cd\Program Files\Honeywell\TPS\hci<
and press <Enter>.
11. Key in this command:
>regsvr32 gopc.dll<
and press <Enter>.
12. A gopc.dll registration succeeded message appears. Click OK.
13. Close the DOS window.
Backing up a ProcessLogix Server to Tape
If your PC has a tape drive, refer to Backing Up a ProcessLogix Server
to Tape on page 1-6 to back up your Server to tape.
Creating an Emergency Repair Disk
After all installations and drivers are installed, create your Emergency
Repair Disk. Use the following procedure to create an emergency repair
disk for your Windows NT installation.
1. Insert a blank diskette into the floppy drive.
2. Click Start
⇒
Run.