Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 184)

Publication 1757-IN032B-EN-P - April 2001
4-20 Additional Redundant Server Procedures
c. Close the ProcessLogix Server dialog box.
2. Refer to Configuring Stations in QuickBuilder on page 4-18.
Setting up Station on SERVERA
Refer to Setting Up Station on SERVERA on page 1-67 to be sure any
ProcessLogix Clients are pointing to the correct computer name or IP
address.
Upgrading Hardware
Component Firmware 1. Refer to Loading 1757-PLX52 and TC-MUX021 Boot and
Personality Images on page 2-10 to upgrade the 1757-PLX52
boot and personality images to the current release level.
2. After upgrading the 1757-PLX52, refer to Upgrading Hardware
Component Firmware on page 2-1 to check if other hardware
components require upgrades.
Making Post ProcessLogix
Software Installation
Checks for a Redundant
Server Pair Restarting Redundant Servers
Refer to Restarting Redundant Servers on page 4-13.
Synchronizing ERDB on Redundant Servers
Refer to Synchronizing ERDB on Redundant Servers on page 1-63.
Synchronizing Server Databases on Redundant Servers
IMPORTANT
Stop! It is mandatory that you check the firmware
revision levels for ALL ProcessLogix hardware
components after a ProcessLogix software
installation and/or a component addition or
replacement.
Do not proceed until you have upgraded the
firmware. Then go to the next section, Making Post
ProcessLogix Software Installation Checks for a
Redundant Server Pair.