Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 190)

Publication 1757-IN032B-EN-P - April 2001
5-4 Supplementary Procedures
1. If you have not already done so, click
Start
⇒
Programs
⇒
ProcessLogix Engineering Tools
⇒
Uninstall
ProcessLogix Update.
2. At the Uninstall ProcessLogix window, enter 1.
3. Click Start
⇒
Run.
4. Key in this command in the Open entry field:
>cmd<
and click OK to open the DOS window.
5. At the DOS prompt, key in the following entries in succession:
>erserver –remove<
>sysrep –remove<
>pscdasrv –remove<
>ersync – remove< (on SERVERB node only)
6. Click Start
⇒
Settings
⇒
Control Panel.
7. Double-click the Add/Remove Programs icon.
8. Select ProcessLogix Engineering Tools R320.0 from the list box.
9. Click Add/Remove.
10. Click Yes to confirm file deletion.
ATTENTION
!
Before uninstalling the ProcessLogix update from a
Client PC, you MUST uninstall all Client applications.
Refer to Removing ProcessLogix Client Software on
page 5-3.
TIP
Step 3 through Step 5 apply only to ProcessLogix
Servers. If you are configuring a ProcessLogix Client,
skip to Step 6.