Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 31)

Publication 1757-IN032B-EN-P - April 2001
System Software Upgrade Procedures 1-11
Installing Service Pack 6a
for Windows NT 4.0
For your convenience, we have included Service Pack 6a for Windows
NT 4.0 on the ProcessLogix R320.0 software CD. This is also available as
a free download from the Microsoft web site
(
www.microsoft.com/downloads/search.asp?) .
Use the following procedure to install Service Pack 6a.
1. Insert the ProcessLogix R320.0 software CD into the CD-ROM
drive.
2. Click Start
⇒
Run.
3. Key in this path location in the Open entry field or use Browse to
navigate to the sp6i386.exe file on the CD.
>D: (or your CD-ROM drive letter)\nt_sp6a\sp6i386.exe<
4. Click OK to launch the Service Pack 6a setup application.
5. If a third-party system utilities message appears, click OK.
6. At the Setup window, check the boxes:
•
Accept the License Agreement
•
Backup files necessary to uninstall the Service Pack at a later
time.
7. Click Install to initiate the Service Pack 6a update.
8. If a window appears requesting you to replace a vendor installed
file, click Yes to replace the file with the one provided by the
Service Pack Setup.
9. At the Setup complete window, remove the CD and then click
Restart. The PC automatically restarts.
IMPORTANT
Your system should be running Service Pack 6a. If it is
not running Service Pack 6a, follow this procedure to
install it.
ATTENTION
!
Before installing or uninstalling any software
component, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
Refer to Stopping ProcessLogix Applications and
Services on page 1-8.